Far North QueenslandYacht Guide

Far North Queensland Yacht Guide

Fuel Planning and Bunkering for an Offshore Passage from Cairns: How Much to Carry and Where to Stop

The passage from Cairns to Thursday Island runs approximately 550 nautical miles. Much of that coastline is remote, the fuel stops between Cooktown and Thursday Island can be counted on one hand, and the wind - which determines how much of that distance you motor rather than sail - is seasonal and not guaranteed to cooperate. Getting the fuel numbers right before you cast off a Marlin Marina berth is the foundation of a managed passage, not a detail to revisit at the first anchorage.

Why Fuel Planning from Cairns Is a Distinct Problem

The Queensland coast north of Cairns is not a continental-shelf hop where a marina or fuel dock appears every 50 miles. Cooktown, roughly 135 nautical miles from Cairns, is the last full-service mainland port. Beyond it, the Cape York coastline runs remote for hundreds of miles - Princess Charlotte Bay, Lizard Island, and the tip of Cape York offer anchorages, not fuelling stations. The gap between Cooktown and Weipa, and from Weipa to Thursday Island, defines the planning problem in a way that most passages along the Queensland coast simply do not.

Three compounding factors make this route distinct. Trade wind reliability varies even within the favoured June-September window; reef navigation between anchorages requires motoring regardless of offshore conditions; and the Torres Strait passage does not end at Thursday Island - it stages an onward leg to Darwin, Gove, or Indonesia, all of which demand their own reserves. A plan built on optimistic sailing assumptions will fall short at Weipa or leave you light through the strait.

The character of the infrastructure gap also matters. Each fuel stop along the Cape York chain is served by a single commercial operator. If Evans Landing Wharf at Weipa is inaccessible due to weather or vessel traffic, there is no alternative around the corner. This is different in kind from mainland coastal cruising, where options exist. Plan as if each stop is the only stop.

Ford: Diesel fuel pump
Photo: lydia_shiningbrightly (BY)

Bunkering in Cairns

Marlin Marina Fuel Dock

The main diesel berth at Cairns Marlin Marina operates under Ports North with supply from Viva Energy. Both diesel and ULP are available from the main fuel dock. The pump capacity is high - filling a standard cruising yacht takes a matter of minutes rather than the extended wait typical at smaller facilities. For large vessels, full fuel truck deliveries direct to a superyacht berth are also available.

During June through August, when northbound fleet departures cluster, calling ahead to confirm berth availability is worth doing the day before you plan to fuel. Contact Ports North harbour operations or call the marina on VHF 16 to arrange timing. Arrive with an idea of your required volume; the dock can handle fast fills but you want your supplementary containers ready to load in the same session.

Trinity Petroleum Truck Bunkering

For large fills - particularly when topping up both a main tank and supplementary containers in a single session - truck bunkering is the more practical choice. Trinity Petroleum holds ISO quality management accreditation for fuel distribution and operates across all Cairns Shipyards locations, Cairns Marlin Marina, and Trinity Wharf. They also offer de-bunkering for vessels being lifted onto the hard, which is useful if you are hauling a boat with a full tank that needs draining before repair work.

The practical advantage of a truck delivery is that it comes to you. You arrange a time, the truck arrives at your berth or hardstand position, and you can fill the main tank, any auxiliary built-in tanks, and all deck containers in one session without moving the vessel. Contact details and minimum order volumes are confirmed directly with Trinity; current information is findable through the Cairns Shipyard or Ports North directory.

Timing Your Fill Around a Haulout

If a haulout precedes your offshore departure, the optimal sequence is to have the tank cleaned or polished during the haul - see the site's diesel contamination guide for the full process - then arrange a Trinity Petroleum delivery to the hardstand before the vessel splashes. You step aboard with a full, polished tank verified by dipstick, and you log that figure as your departure baseline. This matters for insurance records and, should a customs query arise, as documentation of your fuel state at the point of leaving Australia.

Calculating Your Diesel Requirement

Tank Capacity on Common Cruising Boats

Production cruising sailboats in the 35-45 foot range vary considerably in built-in tank capacity. A Baltic 40 carries around 120 litres; a Hunter 40.5 around 150 litres; a Bermuda 40 around 180 litres; an Endeavour 40 around 280 litres. Dedicated long-range designs built for extended passagemaking can carry up to 800 litres. These numbers matter because a 150-litre standard tank on a 40-footer is simply not enough to reach Weipa from Cairns without supplementary capacity, and planning should acknowledge that before departure rather than at Cooktown.

Consumption and Motoring Range

An auxiliary diesel in the 35-45 foot range, running at around 2,200-2,600 rpm, burns approximately 2-5 litres per hour depending on engine size, hull load, and sea state. A conservative planning figure for a mid-range engine running at 5 knots is 4 litres per hour, giving a motoring range of roughly 250 nautical miles from a 200-litre tank. The Cairns-to-Thursday-Island passage in stages typically takes a production cruiser 5-8 days. Daily reef navigation stints - entering and leaving anchorages through cuts and bommies in flat-light conditions - add 10-20 litres per day over and above the pure sailing baseline. Plan for motoring, not against it.

Applying the One-Third Rule

Allocate one-third of total fuel for the outbound passage, hold one-third as contingency, and treat one-third as a hard reserve - never touched in normal planning. A boat that leaves port with only enough fuel to reach its next stop has no margin if conditions deteriorate or the destination is inaccessible on arrival.

In practice: if a passage leg requires 300 nautical miles of motoring range, you should depart with enough fuel for 450 nautical miles of motor range, with 150 of those nautical miles held as the untouchable reserve. Apply the rule segment by segment - Cairns to Cooktown, Cooktown through to Weipa, Weipa to Thursday Island - not across the whole passage in aggregate. Each leg starts with its own calculation before you leave the previous port.

Work through each leg in this sequence before departure:

  1. Measure your actual usable tank capacity by dipstick - not the gauge, which typically reads optimistically when heeled or in a seaway.
  2. Estimate motoring hours for the next leg at your passage-planning wind assumptions, then add a 20-percent buffer for calms, contrary angles, and anchorage entry and exit stints.
  3. Multiply total motoring hours by your engine's consumption rate at cruise rpm to get the volume needed for the leg.
  4. Apply the one-third rule: total fuel required equals 1.5 times the calculated leg volume, with the extra 50 percent held as your departure reserve.
  5. If your on-board capacity does not cover that figure, calculate the supplementary deck fuel you need and arrange it before departing the current port - not en route.

The Cape York Fuel Chain, Port by Port

PortDistance from CairnsFuel availableKey notes
Cooktown~135 nmDiesel and ULP, marina and townLast full-service mainland port; provision thoroughly here
Lizard IslandNorth of CooktownNoneNational Park anchorage only - depart Cooktown with the full Cooktown-to-Weipa leg planned
WeipaCape York PeninsulaBulk diesel - Viva Energy, Evans Landing WharfPrincipal Cape York bulk stop; most production cruisers must stop here
Thursday Island~550 nmDiesel - Sea Swift, main wharfStandard final Australian port for westbound departures through the strait

Cooktown

Cooktown is the natural first stop and the last opportunity to provision fully before the remote coast begins in earnest. At 135 nautical miles from Cairns it is a comfortable one-night passage with an early departure. Top up fuel and water, buy fresh food, check gas bottles. This is also the moment to confirm Weipa berth timing and contact details while mobile coverage is reliable, since Evans Landing Wharf may need advance notice for commercial vessel priorities. The marina can accommodate most cruising draughts; call ahead on VHF 16 or check Queensland Boating and Fisheries current depth and berth notes before arrival.

Lizard Island

Lizard Island has no commercial fuel. This is a fixed planning constraint, not a temporary service gap. Depart Cooktown with enough diesel to cover the entire Cooktown-to-Weipa leg without touching your reserve - Lizard Island functions as an overnight anchorage only. Confirm National Park permit requirements before arrival; camping and anchoring rules are listed on the Queensland Parks website and are worth checking before departure from Cooktown.

Weipa

Evans Landing Wharf at Weipa, operated by Viva Energy, is the backbone of the Cape York fuel chain. Most production cruisers arrive from Cairns unable to bypass Weipa and continue to Gove or Thursday Island in a single run - the leg from Cairns simply requires more diesel than a standard 40-footer carries built-in. The approach involves bar crossing and tidal considerations; arrange arrival procedures directly with the marina or the wharf before departing Cooktown. Current contact information for the Weipa marina and Evans Landing Wharf is available through Viva Energy's Queensland commercial marine division and is worth confirming before you lose the reliable mobile coverage that Cooktown still has.

Thursday Island

Sea Swift on the main wharf handles diesel for most vessel types calling at Thursday Island. The island is the conventional staging port for westbound passages through the Torres Strait, and topping up here before departure is standard practice. Call ahead to confirm tidal access windows for deeper-keeled vessels. Have customs clearance paperwork and any required CAIT permits sorted before you arrive; Australian Border Force and AMSA both maintain current requirements online and the paperwork cannot be completed after the fact if you depart without it.

Wind Versus Fuel - the Trade Window

The southeast trade winds run through the Torres Strait from approximately April to November, with June through September the most consistent and reliable band. A westbound passage on a steady trade wind runs off the wind or on a broad reach for much of the Cape York-to-Thursday-Island leg. Motoring stints shrink to anchorage entry and exit, and daily consumption for the final sections of the route drops substantially compared to a calm-weather motoring passage.

Outside that window the fuel arithmetic changes sharply. A May departure may catch the beginning of the trades but face unpredictable calms and variable winds through the inner reef passages. An October departure catches the dying edge and runs the risk of the northwest monsoon establishing before the Torres Strait transit is complete. The difference in total motoring time between a June departure and an October departure on the same route can be two to three full days of engine running - a significant volume on a standard production cruiser tank.

For skippers timing a return south from Indonesia or Darwin in October-November, the dominant condition is a light northwest - comfortable for a downwind run to Australia but with a likely motoring component for the Gove-to-TI section against whatever residual trades remain. Plan Gove accordingly and do not assume the return will be sail-only.

Extending Your Range: Jerry Cans and Fuel Bladders

Jerry Cans and Australian Regulations

Portable fuel containers must comply with the current Australian Standard for portable petrol and diesel containers and carry UN approval markings. There is a personal-use ceiling above which commercial dangerous-goods compliance applies; verify the current threshold with your state's workplace health and safety authority before loading deck fuel, since the figure is set by regulation and can change. Within that limit, a set of approved cans provides a practical range buffer - 100-120 extra litres is enough to give a 150-litre-tank boat comfortable headroom for the Cooktown-to-Lizard-Island overnight without touching the main reserve allocation.

Deck stow rules for portable fuel are not negotiable at sea:

Flexible Fuel Bladders

For range extensions beyond what a reasonable number of cans can provide - particularly the long Cooktown-to-Weipa leg that cannot be broken with a fuel stop - flexible fuel bladders are the better choice. Well-made bladders use TPU-coated polyester construction, which resists UV and salt degradation better than the cheaper PVC alternatives found in some chandleries. The critical safety feature is the breakaway coupling: if the bladder goes overboard in a seaway, the fitting separates rather than siphoning the main tank. Transfer is via a self-priming electric pump routed through a water separator into the main tank - never by gravity alone, which risks uncontrolled flow and water contamination of your primary fuel supply.

Bladders make more sense than cans when:

Cans make more sense when:

Fuel for Onward Passages Beyond Thursday Island

Thursday Island is the staging point for three distinct onward routes, each with different fuel demands through the strait and beyond. The planning principle is the same: depart TI with a full tank regardless of destination, and calculate each subsequent leg under the one-third rule from that confirmed baseline.

Westbound to Darwin requires a Gove stop as an intermediate port. Depart TI with enough fuel for the TI-to-Gove leg under the one-third rule. Gove has diesel available; confirm current supplier details through the Northern Territory port authority and the Cruising Yacht Club of Australia route notes before departing TI rather than on arrival at Gove, when your options are limited. The Gove-to-Darwin leg is shorter, but Darwin approaches involve tidal rapids through the strait and navigation that may require motoring regardless of wind.

Westbound to Kupang, Indonesia, is a relatively short offshore leg from TI across the Timor Sea. Most production cruisers can carry enough fuel for this leg if topped up fully at the Sea Swift wharf before departure. Customs clearance, Australian Border Force exit procedures, and CAIT permits must be sorted before departure - the ABF and AMSA websites carry current requirements and processing arrangements that change periodically.

Pre-Departure Fuel Checklist

The sequence below applies to any departure from Cairns for a Cape York or Torres Strait passage: